Stratasys Objet Connex 260 Polyjet Printer, Stratasys Objet Eden 260 Polyjet Printer

Materials: Type: Proprietary acrylate based polymer. Rigid White & Flexible Translucent (which can be combined to achieve intermediate mechanical properties).  Alternatively, Rigid Translucent/Clear (Clear achieved with polishing)
Properties:
Variable mechanical properties but moderately low yield stress at highest stiffness. Behaves much like standard acrylic, unless blended with flexible material.  Alternative materials can be rubber-like in mechanical properties, or clear/translucent.

Accuracy: Extremely high: 16/32 micron layer thickness, Overall 0.05mm to 0.15 mm accuracy (depending on geometry).  Smallest free-standing feature approximately 0.25mm to 0.3mm Support Structures:  Gel-Like secondary material (Removed with water jet).  

Maximum Build Dimensions: 10.2×10.2×7.9 inches (260x260x200 mm)(Both Systems, single or multimaterial)

Build Time: Total: 30 minutes – 5+ Hours (dependent on geometry & size)
*Turnaround time is workload dependent.  Expedited parts may come with an additional fee.

Cost: UC: (at cost) Standard Material (Rigid and Flexible):  $5/10 grams of build material + $3/10 grams of support material + $3/hr of build time + setup and cleaning fee. Clear Material:  $7/10 grams of build material + $4/10 grams of support material + $3/hr of build time + setup and cleaning fee. Outside UC: 32% Premium (above cost)

Pros: Extreme accuracy, Parts can be printed as functional assemblies, functional prototypes (or direct application in light-duty).  Variable mechanical properties.  Near limitless geometric configurations

Cons: Material (generally) not as strong as FDM, or SLA techniques. Cost is comparatively higher than FDM or SLA.


MaterialsVero+Tango+Gray60MED610
ColorWhite
Black
(upon request)
Translucent
Black
Gray
Blue
Clear
Properties Rigid acrylic
Data sheet
Flexible vinyl
“rubber like”
Data sheet
Hybrid
between
Vero+
and
Tengo+
Data Sheet
Rigid
ideal for
prolonged
skin contact
Data sheet
Cost UC (at cost):
+$5/10g of build material
+$3/10g of support material
+$3/hr set-up time
+set up/cleaning fee *
UC (at cost):
+$5/10g of build material
+$3/10g of support material
+$3/hr set-up time
+set up/cleaning fee *
UC (at cost):
+$5/10g of build material
+$3/10g of support material
+$3/hr set-up time
+set up/cleaning fee *
UC (at cost):
+$7/10g of build material
+$4/10g of support material
+$3/hr set-up time
+set up/cleaning fee *

         *If outside UC, then 32% above the cost